HYPAC Hydraulic Systems - AC Power Units

AC Power Units

HYPAC power units are for intermitted duty and normally used in conjunction with double-acting cylinders where intermittent, automated, reciprocal motion is required. Satisfactory for use with any number of cylinders as long as quantity to be operated simultaneously does not exceed reservoir capacity and reduced cylinder stroke speed is acceptable.

Special configurations such as greater horsepower, increased flow or reservoir capacity are available where circumstances and volumes dictate.

All HYPAC power units conform to Underwriters Laboratories requirements for current leakage and temperature rise for medical and dental equipment. No radio or electrical equipment interference. Power units provide multiple modes of motion through use with solenoid-operated cylinders.

Specifications for standard AC voltage power units:

Motor:	Type: Horsepower: RPM: Volts: Hertz: Duty: Protection: Voltage Leak: Enclosure: Insulation:	Permanent Spilt Capacitor (Reversible) .33/.25 3150/1550 115 & 220 Single Phase 60 (115 V) & 50 (220 V) Intermittent/Continuos Thermal Overload (Auto Reset) 30 Microamperes Max. Open Drip Class B
Pump:	Type: Flow: Pressure: Reservoir Cap:	Gerotor .5 GPM to 1 GPM (Ref.) 600 PSI Relief in Both Directions 19, 25, 60 Cubic Inches

DESCRIPTION	PART #	PART #
AC Power Units	Hanging	Upright
115v Motor/Pump/Res Unit 1/3 hp - 25 cu. in. Reservoir Standard*
1/2 gpm - 600 psi	2021020	2021021
3/4 gpm - 600 psi	2101005	2101004
1 gpm - 600 psi	2024482	2024483
115v Motor/Unit/With Capacitors/Wiring 1/3 hp
1/2 gpm - 600 psi	2021280	2021281
3/4 gpm - 600 psi	2101007	2101006
1 gpm - 600 psi	2024486	2024487
220v Motor/Pump/Reservoir Unit 1/3 hp
1/2 gpm	2021025	2021026
3/4 gpm	2101029	2101021
1 gpm	2024484	2024485
220v Motor/With Capacitors/Wiring 1/3 hp
1/2 gpm	2021282	2021783
3/4 gpm	2101030	2101031
1 gpm	2024488	2024489
Conversion Kit - 115v Unit 1/2 gpm w/mtg. plate	2021761	2021762

* 19 & 60 cu. in. Res. available upon request
** Capacitors necessary for power unit to operate

2101196

NOTE: Upright (Mounting Feet Down) Type shown. On Hanging (Mounting Feet Up) Type, Mounting Feet Are 180 Opposite. Either Type May Be Operated Vertically With Reservoir End Up.

B A C K